1. Ampere meter can only be connected to 5v input end of the module.2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.3. The connection wire should not be too thick.4. Make sure the connect point is good.5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.6. NO Reveral polarity.
You can leave your phone number for better service, the post office will able to contact you and please don't worry, we won't record your private information.
Normally shipping cost is within $4 ~ $6
Soil Humidity Hygrometer Moisture Detection Sensor Module Arduino w/Dupont Wires Description: 1. This is a.....
CN3069 Basic Information Manufacturer CN Package: HSIP-9---------- Payment ACCEPT: .....
30A range Current Sensor Module ACS712 Module Basic Information Manufacturer orzparts Package: 31x13mm Supply.....
2200uF/25V Electrolytic Capacitor 12*20mm Basic Information Manufacturer - Package: 12.0mm x 20.0mm Qty:.....
AD9850 DDS Signal Generator Module 0~40MHz Test Equipment Basic Information Manufacturer orzparts Package: 45x26mm .....
3300uF 16V Electrolytic Capacitor 10*25MM Basic Information Manufacturer - Package: 10*25MM Qty:.....